Here is a list of all variables with links to the structures/unions they belong to:
- s -
- sample_data : pvt_cntl_ts_pd_sdif_data_reg_t
- sample_fault : pvt_cntl_ts_pd_sdif_data_reg_t
- sample_type : pvt_cntl_ts_pd_sdif_data_reg_t
- sb_phase : security_fd_flags
- scheme : switch_clk_scheme_rqst
- scl_stuck_at_low : DW_APB_I2C_IC_RAW_INTR_STAT_reg_t
- sclk_disable : RESET_UNIT_UART_CNTL_reg_t
- sd_mode_sel_0 : RESET_UNIT_PCIE_MISC_CNTL3_reg_t
- sd_mode_sel_1 : RESET_UNIT_PCIE_MISC_CNTL3_reg_t
- sdif_addr : pvt_cntl_sdif_reg_t
- sdif_busy : pvt_cntl_sdif_status_reg_t
- sdif_lock : pvt_cntl_sdif_status_reg_t
- sdif_prog : pvt_cntl_sdif_reg_t
- sdif_wdata : pvt_cntl_sdif_reg_t
- sdif_wrn : pvt_cntl_sdif_reg_t
- security_flags : tt_boot_fs_fd
- selected_reg : jtag_emul_data
- self_reset : RESET_UNIT_ARC_MISC_CNTL_reg_t
- send : occp_backend
- send_data : smbus_target_data
- send_handler : SmbusCmdDef
- send_index : smbus_target_data
- send_pci_msi : request
- sensor_id : read_pd_rqst, read_ts_rqst, read_vm_rqst
- seq_num : cm2dmAck, cm2dmMessage
- ser_np : PCIE_SII_NOC_TLB_DATA_reg_t
- serdes_inst : CntlInitV2Param
- serial_number : set_last_serial_rqst
- set_asic_host_fmax : request
- set_last_serial : request
- set_tdp_limit : request
- set_voltage : request
- set_wdt_timeout : request
- settings : clock_control_tt_bh_data
- setup : jtag_api
- shift_bits : jtag_emul_data
- shift_reg : jtag_emul_data
- sidebands_reserved : NOC2AXITlb2RegT
- signature_size : security_fd_flags
- size : clock_control_tt_bh_config, regulator_data
- skip_eth_hi : debug_noc_translation_rqst
- skip_eth_low : debug_noc_translation_rqst
- slave_addr : get_voltage_rqst, set_voltage_rqst
- slv_rasdp_err_mode : PCIE_SII_APP_PCIE_CTL_reg_t
- smbus : bh_arc
- smbus_arp_en : DW_APB_I2C_IC_CON_reg_t
- smbus_persistent_slv_addr_en : DW_APB_I2C_IC_CON_reg_t
- smbus_slave_quick_en : DW_APB_I2C_IC_CON_reg_t
- smlh_link_up_sync : PCIE_SII_LTSSM_STATE_reg_t
- smlh_ltssm_state_sync : PCIE_SII_LTSSM_STATE_reg_t
- soft_reset : RESET_UNIT_ARC_MISC_CNTL_reg_t
- source : switch_vout_control_rqst
- source_x : tt_bh_dma_noc_coords
- source_y : tt_bh_dma_noc_coords
- sp : UART_ADDRESS_BLOCK_LCR_reg_t
- spare : STATUS_BOOT_STATUS0_reg_t
- spec : pvt_tt_bh_rtio_data
- speed : DW_APB_I2C_IC_CON_reg_t
- spi_addr : tt_boot_fs_fd
- spi_address : eeprom_rqst
- spi_mux : bh_chip_config
- spi_reset : bh_chip_config
- sram : jtag_emul_data
- sram_len : jtag_emul_data
- sreset : RESET_UNIT_UART_CNTL_reg_t
- start_det : DW_APB_I2C_IC_RAW_INTR_STAT_reg_t
- state : arc_dma_channel, jtag_emul_data, smbus_target_data, tt_bh_dma_channel_data
- stop : UART_ADDRESS_BLOCK_LCR_reg_t
- stop_avs_clock_on_idle : APB2AVSBUS_AVS_CFG_1_reg_t
- stop_det : DW_APB_I2C_IC_RAW_INTR_STAT_reg_t
- stop_det_if_master_active : DW_APB_I2C_IC_CON_reg_t
- stop_det_ifaddressed : DW_APB_I2C_IC_CON_reg_t
- stop_mask : BH_PCIE_DWC_PCIE_USP_PF0_HDMA_CAP_HDMA_INT_SETUP_OFF_RDCH_0_reg_t, BH_PCIE_DWC_PCIE_USP_PF0_HDMA_CAP_HDMA_INT_SETUP_OFF_WRCH_0_reg_t
- strapping : bh_chip_config
- stride_x : NOC2AXITlb3RegT
- stride_y : NOC2AXITlb3RegT
- strobe : EFUSE_CNTL_EFUSE_RD_CNTL_reg_t
- submsg_data : characterisation_msg_rqst
- submsg_ID : characterisation_msg_rqst
- sweep_en : AiclkPPM
- sweep_high : AiclkPPM, aisweep_rqst
- sweep_low : AiclkPPM, aisweep_rqst
- switch_clk_scheme : request
- switch_vout_control : request
- system_reset_n : RESET_UNIT_GLOBAL_RESET_reg_t
1.14.0